Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 39)

39Hangar 9 Alpha 40 ARF Assembly Manual

 Step 5

Use a #1 Phillips screwdriver and the screws provided with

the servo to secure the aileron servo in the wing.

 Step 6

Use a hobby knife to cut a 1/4-inch (6mm) piece from the

safety tubing. Slide the tubing onto a nylon clevis. Thread the

clevis 10-turns on a 6-1/8-inch (155mm) threaded pushrod.



Step 7

Use a ruler and measure 4

-inch (111mm) from the pin in

the clevis. Use a felt-tipped pen to mark the pushrod wire. Use

pliers to make a 90-degree bend in the pushrod wire as shown.

 Step 8

Measure 3/8-inch (10mm) up from the bend and use

diagonal cutters to trim the pushrod wire as shown.

 Step 9

Repeat Steps 6 through 8 to make a second aileron

pushrod wire.

 Step 10

Remove the servo horn from the aileron servo. Use side

cutters to remove the two shorter arms from the servo horn.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 39