Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 40)

40 Hangar 9 Alpha 40 ARF Assembly Manual

 Step 11

Use a pin vise and 5/64-inch (2mm) drill bit to enlarge the

holes in the servo arm that are 1/2-inch (12mm) from the

center of the horn as shown.

 Step 12

Plug the aileron servo into the extension inside the fuselage.

Turn on the transmitter and center the aileron stick and trim.

Attach the servo horn to the servo using the screw provided

with the servo and a #1 Phillips screwdriver.

 Step 13

Connect the aileron linkages to the holes of the servo horn

that were enlarged in the previous steps. Use the pushrod

snap links for this step.

Wing Assembly

Required Parts

Wing panel (left and right) Aluminum wing tube

Clear tape

Note: The following covers the assembly of the wing

without the use of glue. The wing, when joined in this

method, is very strong and does not need to be glued

together. You will want to purchase additional clear tape

if you plan on breaking the wing down into two pieces

for transportation purposes.

 Step 1

Locate the items necessary to join the left and

right wing panels.

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 40