Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 44)

44 Hangar 9 Alpha 40 ARF Assembly Manual

Wing Installation

Required Parts

Wing Fuselage

Rubber band (10)

 Step 1

Locate the rubber band to secure the wing to the fuselage.

 Step 2

Locate the aileron extension that is inside the fuselage. Align

the colors from the aileron servo lead with the extension so

they match, then plug them together.

 Step 3

Start securing the wing to the fuselage by installing two of

the rubber bands.

Hint: Always start with the cross rubber bands. This

will keep the wing from twisting on the fuselage when

installing the remaining rubber bands.

 Step 4

Install a second set of rubber bands on the wing

as shown.

 Step 5

Continue installing a total of six or more of the rubber bands,

alternating the direction of each set until they have all been

installed.

Hint: Always end the rubber band installation by

installing the cross rubber bands last. They will help in

keeping all the other rubber bands in position on the

wing dowels.

Hint: After flying, store your rubber bands in a bag with

a small amount of baby powder. This will soak up the fuel

that is on the rubber bands, making them last longer.

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 44