Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 35)

35Hangar 9 Alpha 40 ARF Assembly Manual

 Step 6

Place the small washer on the opposite side of the horn. The

connector is then secured using a small E-clip. Use pliers to

snap the E-clip in position.

 Step 7

Slide the 2-56 x 28-inch pushrod wire into the tube in the

fuselage for the rudder. Make sure the threaded end goes

into the tube first. Use a hobby knife and #11 blade to trim

the covering on the fuselage where the pushrod exits.

 Step 8

Use a hobby knife to cut a 1/4-inch (6mm) piece from the clear

safety tubing. Slide the tubing onto the clevis, and then thread

the clevis 10-turns on the rudder pushrod wire as shown.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 35