Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 32)

32 Hangar 9 Alpha 40 ARF Assembly Manual

 Step 4

Connect the clevis to the center hole of the elevator control

horn. Slide the safety tubing over the forks of the clevis to

prevent it from opening accidentally.

Attach clevis

to center hole

 Step 5

With the radio system on, center the stick and trim for

the elevator at the radio. Check that the servo horn on the

elevator servo is centered, and that the arm with the hole

1/2-inch (13mm) from the center of the horn is facing

toward the elevator pushrod wire.

 Step 6

Use a ruler to make sure the elevator is centered with the

stabilizer. Use a felt-tipped pen to mark the pushrod wire

where it crosses the hole on the servo horn.

 Step 7

Use pliers to bend the pushrod wire 90-degrees at the mark

made in the previous step.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 32