Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 20)

20 Hangar 9 Alpha 40 ARF Assembly Manual

Landing Gear Installation

Required Parts

Fuselage Main landing gear (2)

Nose gear Steering arm

#4 x 3/8-inch wood screw (4) Landing gear strap (2)

2-56 x 16

-inch steering pushrod

Required Tools and Adhesives

Felt-tipped pen Drill

Drill bit: 5/64-inch (2mm) Phillips screwdriver: #2

Hobby knife with #11 blade Thin CA

Threadlock Medium CA

Alcohol Paper towel

Hex wrench or ball driver: 1.5mm

Note: The landing gear installation is identical if you are

using a glow engine or electric motor.

 Step 1

Locate the items necessary to install the nose gear and main

landing gear on your aircraft.

 Step 2

Connect the steering arm to the 2-56 x 16

-inch steering

pushrod. Note the position of the steering arm and setscrew

hole in the arm in relationship to how the pushrod is

located. If the pushrod is on the opposite side it will bind the

steering/rudder servo during operation.

 Step 3

Slide the pushrod into the pushrod tube in the fuselage.

Position the steering arm between the block on the firewall

as shown. Make sure the hole for the setscrew faces forward

so it can be accessed.

 Step 4

Inspect the nose gear assembly. There is a small notch in

the wire that will align with the hole for the setscrew in the

steering arm.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 20