Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 12)

12 Hangar 9 Alpha 40 ARF Assembly Manual

Muffler Installation

Required Parts

Fuselage Muffler

Required Tools and Adhesives

Hobby knife with #11 blade Hex wrench to fit muffler

 Step 1

Attach the muffler to the engine using the hardware

provided with the engine. Make sure to follow the engine

manufacturer’s instructions where applicable.

 Step 2

Connect the fuel lines to the carburetor and muffler. The line

from the vent will attach to the muffler, while the line from the

clunk will attach to the carburetor. Use scissors or a hobby

knife and #11 blade to trim the length of the line if necessary

so they don’t interfere with the operation of the engine.

Propeller and Spinner - Glow Engine

Installation

Required Parts

Fuselage assembly Spinner assembly

Propeller

Required Tools and Adhesives

Open end or box wrench: 3/8-inch

Phillips screwdriver: #1

 Step 1

Locate the items necessary to install the spinner on your engine.

 Step 2

Check that the flywheel is fully installed on the engine. It fits

closely to the engine when positioned correctly. Slide the

spinner backplate onto the engine crankshaft so it is tight

against the flywheel.

 Step 3

Slide the propeller onto the engine crankshaft. The blades

of the propeller will be positioned against the bosses for the

spinner screws of the spinner backplate as shown below.

 Step 4

Slide the propeller washer onto the engine crankshaft.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 12