Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 46)

46 Hangar 9 Alpha 40 ARF Assembly Manual

Checking the Throttle Operation

Required Parts

Fuselage assembly Transmitter

THROTTLE CLOSED

Move the throttle stick and trim down to the fully closed

position as shown. The carburetor should close without

binding the throttle servo. If the servo binds, you will need to

adjust the clevis at the carburetor by threading it in or out to

eliminate any binding.

THROTTLE OPEN

Move the throttle stick and trim up or to the fully open

position as shown. The carburetor should open without

binding the throttle servo. If the servo binds, you will need to

adjust the clevis at the carburetor by threading it in or out to

eliminate any binding.

THROTTLE SET TO IDLE

Move the throttle stick down to the fully closed position. Move

the trim lever upward to open the carburetor roughly 1/16-

inch (1.5mm). This will be the idle position for your engine.

The idle will be fine-tuned at the field so the engine will idle

reliably without stalling for slow flight and landing procedures.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 52 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 46