Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 10)

10 Hangar 9 Alpha 40 ARF Assembly Manual

Fuel Tank Installation

Required Parts

Fuselage Fuel tank brace, front

Fuel tank brace, rear 3mm washer (2)

Fuselage hatch Fuel tank (assembled)

3mm x 12mm socket head scew (2)

Required Tools and Adhesives

Threadlock Scissors

Hobby knife with #11 blade Phillips screwdriver: #2

Hex wrench or ball driver: 2.5mm

 Step 1

Locate the items necessary to install the fuel tank in the fuselage.

 Step 2

Inspect the fuel tank to determine the internal positioning

of the vent line. This is important as the vent line must face

to the top of the fuselage for the engine to run properly.

You may want to place a piece of tape on the tube that

corresponds to the vent line for easier identification later.

Clunk

Vent Line

Top View

Side View

Vent Line (faces top of fuselage)

To Mufﬂer

To Carburetor

 Step 3

Insert the fuel tank in the fuselage. Guide the fuel lines

through the hole in the firewall.

 Step 4

Guiding the fuel tubes to the top of the fuselage, place the tank

in the fuselage so it rests in the fuselage as shown. The tank

will fit snug against the back of the firewall when installed.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 10