Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 37)

37Hangar 9 Alpha 40 ARF Assembly Manual

 Step 14

Slide the pushrod snap link on the wire. Rotate the link so it

snaps on the wire. You may need to use pliers to snap the

link onto the wire.

 Step 15

Use diagonal cutters to trim the excess wire above the

link so it does not interfere with the operation of the radio

system. Leave a small amount of wire so the pushrod snap

link cannot accidentally slip up and over the wire.

 Step 16

Slide the steering pushrod wire through the pushrod

connector. Use the screw from the servo and a #1 Phillips

screwdriver to attach the horn to the rudder servo.

 Step 17

Center the nosewheel so it is aligned with the centerline of

the fuselage. Use a 3mm x 3mm setscrew and 1.5mm hex

wrench to tighten the setscrew that secures the steering

pushrod wire. Make sure to use threadlock on the setscrew.

Note: If you find that your model does not track straight

on the ground, loosen the setscrew to adjust the steering.

Do not use the rudder trim to adjust the steering. Use the

rudder trim for in-flight corrections only.

 Step 18

If you are going to step away from your model, make sure to

turn off both the transmitter and receiver.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 37