38 Hangar 9 Alpha 40 ARF Assembly Manual
Aileron Servo Installation
Required Parts
Wing panel, right Servo with hardware
Clevis (2) Pushrod snap link (2)
2-56 x 6
1
/
8
-inch pushrod wire (2)
Safety tubing
Required Tools and Adhesives
Drill bit: 5/64-inch (2mm) Drill
Hobby knife with #11 blade Pin vise
Ruler Pliers
Pencil Thin CA
Phillips screwdriver: #1
Step 1
Locate the items necessary to install the aileron servo
in the wing.
Step 2
Install the grommets and brass eyelets in the servo. Place the
servo in the wing with the servo output shaft to the trailing
edge of the wing. Use a pencil to transfer the positions for the
servo mounting screws onto the servo mount.
Step 3
Remove the servo from the wing. Use a drill and 5/64-inch
(2mm) drill bit to drill the four holes to mount the servo.
Hint: Place the drill bit in the drill as far as possible to
avoid accidentally drilling through the top of the wing.
Step 4
Place 2–3 drops of thin CA in each of the holes to harden the
surrounding wood. This will make the screws more secure
and less likely to vibrate loose.
Commentaires sur ces manuels