Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur télécharger pdf (Page 18)

18 Hangar 9 Alpha 40 ARF Assembly Manual

 Step 21

Slide the fuselage hatch in position on the fuselage. The

tabs will lock the front of the hatch in position. Slide a #4

washer on a 3mm x 12mm socket head screw. Place a drop

of threadlock on the screw. Use a 2.5mm hex wrench or ball

driver to tighten the screw. Use two screws and washers to

secure the hatch to the fuselage.

 Step 22

On the bottom of the fuselage, right behind the rear window,

is an area that can be removed to provide cooling air to pass

through the fuselage to cool the motor battery. Removing

this covering is only necessary if you are not using the

newer Li-Po batteries capable of a 25C discharge rate.

Propeller and Spinner Installation-

Electric Motor

Required Parts

Fuselage assembly Spinner assembly

Propeller Propeller adapter

Required Tools and Adhesives

Phillips screwdriver: #1

Hex wrench or ball driver: 3/32-inch (2mm)

 Step 1

Locate the items necessary to install the propeller and

spinner on the motor.

 Step 2

Slide the propeller adapter on the motor as shown.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 53 54

Pas de commentaire

Hangar-9 Alpha 40 ARF Trainer Manuel d'utilisateur Page 18